South CarolinaBusinessesNear Me
Pool Resurfacing Cost in South Carolina: 2026 Prices From the Coast to the Upstate
← All Posts

pool-service

Pool Resurfacing Cost in South Carolina: 2026 Prices From the Coast to the Upstate

Pool resurfacing in South Carolina costs about $6,000 to $15,000. See prices by finish, coastal water table risks, and the best months to book in 2026.

·October 29, 2026·8 min read

Pool Resurfacing Cost in South Carolina: 2026 Prices From the Coast to the Upstate

A pool in Mount Pleasant, SC lives a harder life than most. It sees nine months of swim season, salt air off the harbor, afternoon storms that dump pine pollen and sand, and a water table that sits a few feet below the deck. All of that wears down plaster faster than the 10 to 15 years that brochures promise.

Most South Carolina homeowners pay roughly $6,000 to $15,000 to resurface a typical inground pool this year. Basic white plaster sits at the low end, while pebble finishes on larger pools in Charleston or Hilton Head can pass $18,000. The finish you choose, the size of the pool, and where you live in the state move that number more than anything else.

Price Ranges by Finish Type

The table below shows approximate installed costs for a common 15 by 30 foot pool with roughly 1,000 square feet of interior surface. These ranges include draining, prep, and the new finish, but not tile or coping work.

Bids will vary from one contractor to the next. Use these numbers to spot a quote that seems far too low or out of line.

FinishApproximate CostTypical Lifespan in SC
White plaster (marcite)$5,500 to $8,5007 to 12 years
Quartz aggregate$7,500 to $11,50010 to 15 years
Exposed pebble$10,000 to $16,00015 to 20 years
Polished pebble$12,500 to $18,50015 to 20 years
Fiberglass gelcoat refinish$5,000 to $9,00010 to 15 years

Plaster is the cheapest, but it etches quickly in pools that run salt chlorine generators, which are common in Lowcountry neighborhoods. Pebble costs more up front and usually holds up longest against salt and high temperatures. Quartz is the middle option many Columbia and Greenville homeowners choose.

Why Coastal Pools Cost More to Resurface

Salt is the main reason. Ocean air carries salt inland several miles, and many pools along the Grand Strand and in Beaufort County also use saltwater systems. Plaster exposed to both tends to roughen, stain, and lose its smooth surface years earlier than an inland pool.

The other reason is groundwater. Pools in Myrtle Beach, Murrells Inlet, and the Charleston barrier islands often sit in sandy soil with water a few feet down. Draining one of these pools without checking groundwater can lift the shell out of the ground, a problem pool crews call popping.

Draining Safely Near the Water Table

Experienced coastal crews check the hydrostatic relief valve in the main drain before they pump. Some also drill a well point beside the pool to lower the groundwater while the shell is empty. That added step can add a few hundred dollars to the job, and it is worth paying for.

Timing matters too. Crews in Horry and Georgetown counties prefer to drain after a dry stretch, not right after a week of tropical rain. If a contractor wants to drain your Garden City pool the day after a storm, ask how they plan to manage the water table.

Salt Air and Metal Parts

Resurfacing is a good time to replace corroded light niches, rusted ladder anchors, and pitted rail cups. Coastal pools often need these parts swapped since salt eats through older fittings. Expect about $150 to $400 per item depending on the part.

Rust stains from failing metal can bleed into new plaster within a year. Fixing the source during the resurface saves you from paying for stain treatments later.

Midlands and Upstate Pools

Columbia, SC is one of the hottest cities in the Southeast in summer. Water temperatures in the high 80s speed up chemical swings, and pools that sit unbalanced for a few weeks can etch plaster faster than you would expect. Midlands homeowners in Lexington, Irmo, and Blythewood often resurface every 10 years or so with standard plaster.

Upstate pools in Greenville, Spartanburg, and Anderson deal with red clay soil and more winter freeze cycles. Clay moves when it gets wet and dries out, which can crack decks and stress the bond beam. A good resurfacing contractor will look for shell cracks and repair them before the new finish goes on.

Prices in the Upstate and Midlands tend to run 10 to 15 percent below coastal bids. There is more contractor competition in the larger metros, and crews do not have to deal with high groundwater as often.

What Else Shows Up on the Bill

The finish is only part of the price. Many South Carolina pools need tile and coping work at the same time, and crews often find damage once the old surface comes off.

  • Waterline tile replacement, roughly $2,000 to $5,000
  • New coping stones or poured coping, about $2,500 to $6,000
  • Crack and delamination repairs, $300 to $2,000 depending on size
  • Startup chemicals and the first few weeks of brushing, $200 to $500
  • Water to refill the pool, usually $100 to $400 depending on your utility

Ask for each of these as a separate line item. A single lump-sum bid makes it hard to compare contractors.

Pricing by the Square Foot

Many South Carolina contractors quote by interior square footage instead of by pool. Plaster usually lands around $5 to $8 per square foot, quartz around $7 to $11, and pebble around $10 to $16. To estimate your own pool, multiply length by width, then add the wall area.

A rough shortcut is to take the surface area of the water and multiply it by about 1.4 for a pool with a shallow end and a deep end. A 16 by 32 foot pool on Daniel Island works out to around 700 square feet of water and roughly 1,000 square feet of finish. Freeform and lagoon-style pools common in Bluffton and Hilton Head subdivisions run higher, since curves take more hand work.

Spas attached to the pool are usually priced on their own. Expect to add $1,500 to $3,500 to refinish a spillover spa in the same material.

The Best Time of Year to Resurface

Late fall and early spring are the sweet spots in South Carolina. Crews are less busy, and the weather is mild enough for plaster and pebble to cure well. October through early December and February through April are the most common windows.

Summer resurfacing is harder. Afternoon heat in Columbia and Florence can flash-cure new plaster, which leads to rough spots and cracking. Many contractors schedule summer jobs to start before sunrise to avoid this problem.

Hurricane season is the other factor for coastal homeowners. A drained pool during a tropical storm risks popping, debris damage, and long delays. Most Lowcountry crews avoid draining from late August through early October unless the forecast is clear.

How to Compare Contractor Bids

Get at least three written quotes, and make sure each lists the exact finish brand and color. "Pebble" from one company may be a premium product, while another may use a cheaper blend. The difference shows up in how long the surface lasts.

Ask about the warranty and who stands behind it. Many finish makers offer a product warranty, but workmanship issues like delamination fall on the installer. A local company with years in Charleston or Greenville is easier to reach if a problem shows up.

You can start your search with the South Carolina pool service companies in our directory. Look for crews who list resurfacing as a core service, not just weekly cleaning.

Signs Your Pool Is Ready

Rough plaster that snags swimsuits or scrapes feet is the most common sign. Gray or brown stains that do not brush away, chalky dust on the floor, and spots where the surface has popped loose all point the same direction. Pools that lose chemicals faster than usual can also have porous plaster.

Small cosmetic issues can wait a season or two. A pool with exposed gunite or sharp edges should be resurfaced soon, since swimmers can get hurt and the shell can start to absorb water.

Keeping a New Surface Looking Good

The first 28 days after resurfacing set the tone for the next decade. New plaster needs daily brushing and careful water balance while it cures. Many South Carolina contractors handle this startup process as part of the job, and you should confirm that in writing.

After startup, keep calcium hardness and pH in range, especially on salt pools. A weekly service visit helps catch problems before they stain the new finish. For more pool care and cost guides, see the rest of our blog articles.

South Carolina Pool Resurfacing Questions

How long does it take to resurface a pool in Charleston?

Most jobs take about one to two weeks from drain to refill. Coastal pools can take longer if the crew needs to lower groundwater or replace corroded fittings. Plan for another two to four weeks of startup brushing and chemical care.

Is pebble worth the extra cost on a saltwater pool?

For most coastal homeowners, yes. Pebble finishes often last 15 years or more on salt pools, while plaster may need redoing in seven or eight. Over that span the higher price usually works out to a lower cost per year.

Can I resurface a pool during summer in Columbia?

Yes, but expect the crew to work early mornings and wet the surface often during curing. Afternoon heat over 95°F can cause rough patches in fresh plaster. Fall bids are often 5 to 10 percent lower as well.

Does homeowners insurance cover pool resurfacing?

Insurance rarely pays for resurfacing, since worn plaster is treated as normal wear. A shell damaged by a sudden event like a storm surge may be covered under some policies. Check with your agent before you assume either way.